When You Use A Panasonic Proprietary Telephone - Panasonic KX-TD816 User Manual

2.1 Before Operating the Telephones

When You Use a Panasonic Proprietary Telephone

If you use a Panasonic proprietary telephone and the Console, they may have some of the useful
function buttons listed below. These buttons make operations simple. The illustrations may differ from
the buttons on your telephone.
ANSWER: Used to answer an
ANSWER
incoming call.
AUTO ANSWER / MUTE: Used to
AUTO ANSWER
receive an incoming intercom call in
the hands-free mode or mute the
MUTE
microphone during a conversation.
AUTO DIAL / STORE: Used for System
AUTO DIAL
Speed Dialling or storing programme
changes.
STORE
Call Forwarding / Do Not Disturb:
Used to perform Call Forwarding or Do
Not Disturb or change the display of an
FWD/DND
outside call information.
CO: Used to make or receive an
outside call. A Loop-CO button
(CO) supports all lines. Pressing this button
seizes an idle line automatically.
(Button assignment is required.)
Also used as the desired function
buttons. (Button assignment is
required.)
(Only the CO "number" (e.g. 1, 2) may
be shown on some telephones.)
Conference: Used to establish a three-
party conversation.
CONF
DSS: Used to access the extension.
(Only the "S" may be shown on some
(DSS)
telephones.)
FLASH: Used to disconnect the current
FLASH call and make another call without
hanging up.
22
Function: Located beside the display.
Used to perform the displayed function
or operation.
HOLD: Used to place a call on hold.
HOLD
INTERCOM: Used to make or receive
an intercom call.
INTERCOM
Jog Dial: Used to adjust the volume
and the display contrast or select
desired items for each function.
MESSAGE: Used to leave a message
MESSAGE
waiting indication or call back the party
who left the message waiting
indication.
MONITOR: Used for hands-free
MONITOR dialling. You can monitor the party's
voice hands-free.
PAUSE: Used to insert a pause during
dialling. Used as the PROGRAM
PAUSE
button if it is not equipped.
PROGRAM: Used to enter and exit the
Station Programming mode.
PROGRAM
Programmable Feature: Located on
the upper part of the CO button or on
(PF) the Console. Assigns the desired
button and used to access the stored
function. Mostly used as a one-touch
dialling button.
(Only the "F and number" may be
shown on some telephones.)
Operation