Matrox Millenium II for Mac Installation Manual page 6

Connect your monitor
Simply plug your monitor cable into the monitor connector on your Millennium II card. Make
sure the other end of the monitor cable is properly connected to your monitor. See your monitor
manual for more information.
Bracket
Apple monitors
The wider connector on your Millennium II card is not a
connector for an Apple monitor. To connect an Apple
monitor, use the adapter supplied with your Millennium II
card. Attach the wide end of the adapter to your Apple
monitor cable and attach the other end to the monitor
connector of your Millennium II card.
Install the software
Restart your computer, then insert the install disk in your disk drive. Double-click
, then follow the on-screen instructions. Restart your computer for changes to take
Installer
effect.
The installation program creates*:
Matrox PowerDesk
Matrox 3D Acceleration
Matrox Control Strip
Your hardware and software are now installed. See the next section for information on how to change
your display settings.
* To uninstall the driver, simply remove these files from your system.
6 Matrox Millennium II for Mac – Installation Guide
Monitor connector (blue)
Side-view of your Millennium II card
in your
Control Panel
and
Matrox GDX Mistral
in your
Control Strip Modules
Apple monitor adaptor
folder;
in your
Extensions
folder.
Matrox
folder;