Troubleshooting - Fujitsu A17-3 Operating Manual

FUJITSU A17-3/A19-3

Troubleshooting

Should an error occur, first check the following points. If the distortion is still not eliminated, the
monitor should, if possible, be checked on another computer.
If you are unable to solve the problem, please inform our Service desk.
Having this problem?
No screen display
(power indicator does not light)
No screen display
(power indicator lights)
Message:
No Signal
Message:
This is 85 Hz overdrive.
Change computer display input
to 1024 x 768 at 60 Hz.
Change computer display input
to 1280 x 1024 at 60 Hz.
Picture position not correct
Picture is shaking
22
Downloaded from ManualMonitor.com Manuals
Check the following points:
► Check that the monitor is switched on.
► Check whether the power cable on the monitor is
connected correctly.
► Check whether the computer is switched on.
► Check whether the computer is switched on.
► Check whether the data cable for the monitor is
correctly attached to the monitor port on the
computer.
► Press any key on the computer keyboard - the
computer may be in energy saving mode.
► Alter the brightness and/or contrast until you get a
picture.
► Check whether the data cable for the monitor is
correctly attached to the monitor port on the
computer.
► Check whether the computer is switched on.
The input signal (horizontal frequency and refresh rate)
at the displayed input does not correspond to the
technical monitor data.
► Adjust the video frequency range using the
computer software (see documentation for your
computer or your graphics card).
► Adjust a different screen resolution using the
computer software (see documentation for your
computer or your screen controller).
The monitor recognises an undefined mode.
► Adjust the monitor automatically (using the AUTO
button - if provided - or using the OSD menu).
► Set the picture position with the OSD menu.
► Check whether the data cable for the monitor is
correctly attached to the monitor port on the
computer.
► Adjust the monitor automatically (using the AUTO
button - if provided - or using the OSD menu).
Fujitsu Technology Solutions