Troubleshooting - Fujitsu P2410 Series Operating Manual

Troubleshooting

Troubleshooting

Should an error occur, first check the following points. If the distortion is still not eliminated,
the monitor should, if possible, be checked on another computer.
If you cannot solve the problem, please contact our Service Desk.
Having this problem?
No screen display
Power indicator does not light up
No screen display
Power indicator is lit
Message: No Signal
Message:
Frequency out of range: ## kHz / ## Hz
Please change the display mode to 1920
x 1080 with 60 Hz
Daisy Chain does not work
64
Check the following points:
► Check whether the power cable on the
monitor is connected correctly.
► Check whether the computer is switched on.
► Check whether the computer is switched on.
► Check whether the data cable for the
monitor is correctly attached to the monitor
port on the computer.
► Press any key on the computer keyboard.
The computer may be in power saving
mode.
► Alter the brightness and/or contrast until you
get a picture.
► Check whether the data cable for the
monitor is correctly attached to the monitor
port on the computer.
► Check whether the computer is switched on.
The input signal (horizontal frequency and
refresh rate) at the displayed input does not
correspond to the technical data for the monitor.
► Adjust the video frequency range using the
computer software (see documentation for
the computer or display adapter).
► Set a different screen resolution using the
computer software (see documentation for
the computer or display adapter).
There may not be enough bandwidth to feed the
second monitor.
► Reduce the display refresh rate and/or the
colour depth in the graphics settings of the
system.
Fujitsu