Change The Fuel/Water Separator - ILMOR MV8 Owner's Manual

SECTION 7 ILMOR MV8 OWNER'S MANUAL
7-6

CHANGE THE FUEL/WATER SEPARATOR

WARNING! Always allow the engine to cool down completely before
attempting to service the fuel/water separator filter in order to avoid fire
or explosion.
WARNING! Always be sure that the ignition key is in the OFF position,
the main battery power switch is in the OFF position, and that no spark
or flame are present when servicing the fuel/water separator.
1. Be sure that the key is in the OFF position and that the engine is
completely cooled down.
2. Close the fuel supply valve, if applicable.
3. Locate and remove the fuel/water separator and sealing ring, turning
counterclockwise, being careful not to spill any fuel. Be sure to clean
any spilled fuel immediately.
4. Properly dispose of the used water separator and sealing ring.
5. Coat the new fuel/water separator sealing ring with engine oil.
6. Install the new water separator hand-tight by threading and turning
clockwise.
NOTE: Do not overtighten the fuel/water separator. Never use a filter wrench
to install the fuel/water separator.
7. Open the fuel supply valve, if applicable.
8. Run bilge blower and be sure that the engine compartment is properly
ventilated and free of fuel vapor.
9. Be sure that cooling water is supplied to the engine, and start the
engine.
WARNING! Always make sure that no fuel leaks exist and that the
engine compartment is well ventilated with no gasoline vapors present
to avoid fire or explosion hazard before performing any fuel system
maintenance. Inspect the fuel/water separator for any leaks. Correct any
leak if found, clean spilled fuel immediately and repeat steps 8 and 9.
© 5/2013 Ilmor Marine, LLC, Version 1.0