Check The Power Steering Fluid For Engines With Integral Reservoir - ILMOR MV8 Owner's Manual

CHECK THE POWER STEERING FLUID FOR
ENGINES WITH INTEGRAL RESERVOIR
This procedure applies to boats equipped with power steering systems.
Because this process should be completed while the engine is cool (in order
to avoid burns), it is recommended that this check be completed prior to
starting the engine.
1. Center the steering and stop the engine.
2. Locate the power steering pump at the port side, front of the engine
and remove the fill cap with integrated dipstick (level gauge).
3. Proper fluid level is at the FULL mark.
4. If necessary, add fluid to specified level. Use only fluid as outlined in
Engine Specifications on page 11-1.
NOTICE: If power steering fluid is not visible, contact your Ilmor service
center immediately. Severe engine damage could occur.
NOTE: Power steering fluid does not require changing.
For remote power steering reservoir systems, see the boat manufacturer's
manual for proper maintenance instructions, or contact your authorized
Ilmor service center for assistance.
© 5/2013 Ilmor Marine, LLC, Version 1.0
1) FULL HOT Mark
2) FULL COLD Mark
3) ADD Mark
1
2
3
MAINTENANCE
7-5