Chexpress Cx30 Routine Maintenance; Chexpress Cx30 Maintenance Overview; Inspect The Cx30 Document Track; Cleaning The Cx30 Cameras - Digital Check CheXpress CX30 User Manual

®
CheXpress CX30 User Manual
Rev 041715

CheXpress CX30 Routine Maintenance

CheXpress CX30 Maintenance Overview

Over time, ink, dirt and dust particles will collect on the scanner rollers and in the document track. Therefore, it
is necessary to clean these areas to ensure reliable performance.
Perform a periodic inspection of the document track and use a Digital Check cleaning card to clean the
scanner rollers. Using a can of compressed air will help keep the document track clean.
Inspect the quality of the captured images on a regular basis. If the image quality drops off, clean the camera
glass by following the procedure below.

Inspect the CX30 Document Track

In addition to routine drive roller cleaning, a periodic inspection of the entire document track area is also
recommended. The use of s flashlight will enhance the visual inspection in the camera section and throughout
the document track. Remove any staples, paperclips, debris etc. that might have accumulated during use.
Have a can of compressed air available to blow out the document track on a regular basis. See the 'Accessing
the CheXpress CX30' section for additional information on removing the scanner cover to provide access to
the document track.

Cleaning the CX30 Cameras

To clean the cameras, use a Digital Check cleaning swab or a clean cloth to wipe the camera glass. Be careful
not to scratch the glass when cleaning or accessing the camera for any reason. See the 'Accessing the
Cameras' section for additional information on opening the assembly prior to cleaning.

Cleaning the CX30 Drive Rollers

Use the Digital Check scanner cleaning cards (PN: IS0028 - available at www.digitalcheck.com) for regular
cleaning maintenance.
Note: Use a scanning application or Digital Check's 'ScanLite2' utility to allow the CX30 to feed the cleaning
card. Scanning in 'Pass Through' mode is also recommended. 'Pass Through' mode can be enabled by
opening the rear door of the CX30 prior to running the scanning application or 'ScanLite2'. See the 'Exit Door
Function and Optional Scan Modes' section for more information.
Page | 19