Installing The Ink Cartridge (Continued) - Digital Check CheXpress CX30 User Manual

®
CheXpress CX30 User Manual
Rev 041715

Installing the Ink Cartridge (continued)

Step 3: Insert the nozzle end of the cartridge into the platform first, while keeping the reservoir end of the
cartridge tilted slightly upward. Push the cartridge downward until it snaps into position. The cartridge should
be level with the baseplate when it is fully seated.
Step 4: Replace the center cover by setting it back on the unit vertically. Make sure that both sides of the
'Locking Tabs' are fully latched.
If replacing an existing cartridge, remove the ink cartridge by grasping the small tab at the rear end and gently
pulling upward. Replace the ink cartridge using the steps above.
Note: If the scanner has to be transported by common carrier from one place to another or will experience
extended periods of inactivity, it is advisable to remove the ink cartridge from the scanner and seal it in an
airtight bag. If the cartridge has not been used for an extended period of time, it might be necessary to clean
the inkjet nozzles by blotting them with a towel dampened with water.
Page | 11