Uniden BCD996T Owner's Manual page 81

UB335ZH.book Page 81 Friday, March 17, 2006 4:35 PM
Select a site
Edit Band Plan
You can enter up to 3 band plans. Select the plan to enter or edit, then follow the
prompts to enter the Base Frequency, Channel Step, and Channel Offset for the
site.
Setting P25 Band Plans
The BCD996T includes two operation modes for P25 systems: explicit mode and
implicit mode channel assignment. Explicit mode systems include all information
needed to determine voice frequencies on the control channel. You must supply
the system's band plan for intrinsic systems for the scanner to correctly determine
voice frequencies.
To set the band plan for a P25 system:
[MENU]
Program System
Edit Site
Edit Band Plan
Then, follow these steps:
1. the Band Plan table entry you want to edit and
2. Enter the base frequency for the table entry and
3. Enter the spacing for the table entry (in kHz) and
Repeat 1-3 for additional table entries.
Notes:
• For Explicit mode systems, leave all entries blank.
• There is no way to determine the correct entries using the scanner (other than
trial and error). You must get this information from another source. Uniden
America Corporation does not have this information.
Setting Control-Channel Only Mode
[MENU]
Program System
Select a trunked system
Edit Site (current)
Select a non-P25 site
Set C-Ch Only
(P25 Only)
.
.
.
M (except for P25)
Programming Your Scanner
81