Okina B00PVFKGS0 User Manual page 24

3.5.5 Alarm out
Alarm out includes three sub menus: alarm out, schedule and buzzer
① Alarm out
Step1: enter into system configurationalarm out; refer to Fig 4-27:
Step2: in this interface, set relay alarm out name, select hold time which means the interval time between
the two adjacent alarms.
Step3: user can setup all channels with same parameters, tick off "all", then to do relevant setup.
Step4: click "default" button to resort default setting; click "apply" button to save the setting; click "exit"
button to exit current interface.
② Schedule
Step1: enter into system configurationschedule;
Step2: the setup steps of alarm out schedule are familiar with schedule; user can refer to 4.4.1 Schedule
for details.
Note: the default schedule of motion detection is full-selected, that is, the color of schedule setting
interface is blue.
③ Buzzer
Step1: enter into system configurationbuzzer; (if here sets is off, all event without buzzer)
Step2: tick off Buzzer, set buzzer alarm hold time
Network configuration
3.6
Network configuration includes two submenus: network and network stream.
3.6.1 Network
Step1: enter into system configurationnetwork configurationnetwork; refer to Fig4-28:
Step2: HTTP port: the default value is 80. If the value changed, user needs to add the port number when
typing IP address in IE address blank .i.e. set HTTP port to 82, IP address: http://192.168.0.25, user needs to
input that address: http://192.168.0.25:82
Server port: communication port
Fig 4-27 system configuration-alarm out
Fig 4-28 network configuration-network
into IE browser.
24