Okina B00PVFKGS0 User Manual page 20

Note: the default schedule of motion detection is full-selected, that is, the color of schedule setting
interface is blue.
3.4.3 Sensor
Step1: enter into system configurationschedule configurationalarm; refer to Fig 4-17:
Step2: the setup steps of alarm are familiar with schedule; user can refer to 4.4.1 Schedule for details.
Note: the default schedule of sensor is full-selected, that is, the color of schedule setting interface
is blue.
Alarm configuration
3.5
Alarm configuration includes five sub menus: sensor, motion, video loss, other alarm and alarm out.
3.5.1 Sensor
Sensor includes three sub menus: basic, alarm handling and schedule.
① Basic
Step1: enter into system configurationalarm configurationsensorbasic; refer to Fig 4-18:
Step2: enable sensor alarm, set the alarm type according to triggered alarm type. Two option: NO and NC.
Step3: user can setup all channels with same parameters, tick off "all", then to do relevant setup.
Step4: click "default" button to resort default setting; click "apply" button to save the setting; click "exit"
button to exit current interface.
②
Alarm handling
Step1: enter into system configurationalarm configurationsensoralarm handling; refer to Fig 4-19:
Fig 4-17 schedule configuration-sensor
Fig 4-18 alarm configuration-sensor-basic
Fig 4-19 alarm configuration-sensor-alarm handling
20