Advertisement
60
CHAPTER 3
LINE FEED Button
Use this button to advance the paper one or more
lines.
This button functions only when the SEL light is
off.
1.
Turn the SEL light off by pushing the SEL button
.
2.
Push the LINE FEED button.
3. The paper will move up one line.
You can also use the LINE FEED button to run the local
print test as we demonstrated earlier
:
1.
Turn the printer OFF
.
2.
Push the LINE FEED button and hold it down
.
3
.
Turn the printer ON.
4.
Release the LINE FEED button after about two
seconds.
5. The local print test will print the 96 ASCII charac-
ters in a continuous test pattern
.
6
.
Push the SEL button to stop the local print test.
FORM LENGTH SELECTION DIAL
With this dial you can specify the form length of the paper
you are using. You have a choice of ten positions for paper
lengths of 3" to 14". Position 6 has two possible values:
paper length of 8 .5" with function switch 5 (SW5) ON, and
paper length of 8" with SW5 OFF (see Question 2 on page
29)
.
Use the table below as a guide to select form length.
Advertisement
