Advertisement
46
CHAPTER 3
- - - - - - - - - - - -
Sprocket Paper
The Microline 92 can accommodate multi-part (up to 4-
part) sprocket paper that is either pin-fed without the op-
tional tractor unit, or tractor-fed with the optional tractor
unit (OKIDATA Part No. 54112101).
a.
Pin fed paper, fed by the pins on either end of the
platen, must be 9.5" wide.
b. Tractor-fed paper, fed by the optional tractor unit,
can be anywhere from 3" to 9 .5" wide.
If you don't have the optional tractor unit, go straight to
page 48 for instructions on inserting sprocket paper with-
out the tractor unit.
The Microline 93 can accommodate multi-part (up to 4-
part) sprocket paper anywhere from 3" to 16" wide that is
fed by the standard tractor unit. If you plan to use sprocket
paper on the ML93, you must first install the tractor unit.
Installing the tractor unit (refer to Figure 3-4):
1.
Remove the access cover.
2.
Unlock the paper release lever (position O=open)
.
3.
Hold the tractor unit with both hands on the tractor
side plates.
4. As you face the printer, slip the cutouts in the trac-
tor side plates onto the printer bar shaft.
5.
Make sure the paper release lever is in the
0
(Open)
position.
6. Pivot the tractor unit toward you until the clamps on
either side snap into place over the platen bearing.
Don't be afraid to exert enough pressure to force the
clamps over the platen bearing.
Removing the tractor unit:
1.
Remove paper.
2.
Hold the tractor unit with both hands on the tractor
side plates.
3. As you face the printer, pivot the tractor unit away
from you until the clamps snap off the platen bearing.
Advertisement
