Advertisement
50
CHAPTER 3
- - - - - - - - - - -
Loading sprocket paper with the tractor unit installed
(refer to Figure 3-6):
1.
Turn the printer OFF
.
2.
Remove the access cover.
3. Set the head-gap adjusting lever to position 1 or 2
according to the type of paper used and the number
of copies (see page 56 for instructions on setting
the head gap .)
4. Pull the column indicator (ML93) or tear-off bar
(M L92) away from the platen.
5
.
Insert the paper until it reaches the front of the
platen:
a.
Rear feed
-
insert paper from the rear of the
printer. (Stand the paper guide upright for
rear feed on the ML92)
.
b.
Bottom feed
-
insert paper from the bottom
of the printer base
.
NOTE
:
Printer must be
placed on a slotted printer stand
.
6
.
Unlock both tractors by pulling the lock levers
with your index fingers
.
7. Open the sprocket covers of the tractor unit.
8.
Adjust the left tractor first by sliding it to the left
side, and lock it in place by pushing the lock
lever.
9. Pull the paper up and under the column indicator
(ML93) or tear-off bar (ML92)
.
Engage the paper's
sprocket holes with the sprocket pins of the tractor
unit. Figure 3-7 illustrates steps 6 through 9.
NOTE: Don
'
t move the left tractor more than 2" to the right of the left end,
>O
that the pdper is fed past the PAPER·OUl detector.
10. Adjust the right tractor to the paper width by slid-
ing it, and lock it in place by pushing the lock
lever.
11. Make sure there is no slack in the
paper.
12. When using both tractor and pin feed on the
Micro-
line 92
,
remove paper slackn ess by pushing the
spring-loaded tractor gear to the left with your finger
to disengage it from the idle gear, and turn the tractor
Advertisement
