Advertisement
- - - - - - - - - - - - - - -
Setting Up
Lock the paper release lever (position C =close). This posi-
tion is usually reserved for friction feed.
Move the paper to the point where you want printing to start
by turning the platen knob.
Now that you're ready to roll with ribbon and paper, read
the following to see how to run the local print test.
Fifth-
Make sure that the printer's ON/OFF switch is in the OFF
position
.
CAUTION: Always remember to turn the printer OFF before plugging its power
cord into an outlet. Otherwise, a power surge might cause severe damage to the
printer.
Sixth-
Plug the printer's power cord into a grounded electrical out-
let. The printer must always be grounded
.
Seventh-
Turn the printer ON
.
The SEL and POWER indicators should
light up
.
IMPORTANT: Don't be surprised when the printhead moves as soon as you
turn the printer on. It returns to its "home" (the far left of the carriage) when-
ever the printer is turned ON.
Eighth-
Run the self test.
CAUTION: Be sure you have loaded the ML93 with 132-column or 16" wide paper,
since its print test extends the entire width of the platen.
The test will repeat itself indefinitely until you stop it by
pressing the SEL button
,
or until the printer runs out of
paper.
1. Turn the printer OFF
.
2. Push the LINE FEED button and hold it down.
3. Turn the printer ON again.
4
.
Release the LINE FEED button after about two
seconds.
21
Advertisement
