MAINTENANCE (cont.)
Guide bar wear
Reverse the guide bar (14) every 8 working hours to ensure uniform wear. Check the bar
rails frequently and if necessary remove burs and square-up the rails using a flat file.
Note: The chainsaw warranty does not cover components that have been subjected
to operator abuse or negligence. To receive full value from the warranty, the operator
must maintain the chainsaw as instructed in this manual.
Ozito Industries will not be responsible for any damage or injuries caused by repair of
the tool by an unauthorised person or mishandling or mistreatment of the tool. This
tool is designed for Domestic Home Use only - use in commercial or industrial
environments will void the warranty.
DESCRIPTION OF SYMBOLS
cc
Cubic Centimeters (the standard measure of displacement in Europe and Asia)
n
o
No load speed
/min
Revolutions or reciprocation per minute
dB
Decibel level
Read the manual prior to use
Wear safety boots
Wear safety gloves
Warning
Fuel inlet
(Position: under the fuel tank cap.)
On/Off
(Position: next to the oil tank cap)
Setting the on/off switch to Off,
stops the engine immediately
Pull recoil starter to start motor
Choke control
(Position: next to knob on the filter cover)
Chain brake released (hollow arrow) and activated (solid arrow)
(Position: right side of machine, on chain drive cover)
Electrical Emissions Conformity (EMC)
Do not use chainsaw when
only holding with one hand
Use both hands when using chainsaw
Use eye, ear, head and breathing
protection when operating the chainsaw
Be aware of moving branches
Chain oil inlet
(Position: next to the oil tank cap)
CHOKE Start position (when engine is cold)
START
Start position (when engine is warm)
RUN
Run position
H
High run adjustment screw
L
Low run adjustment screw
T
Idel adjustment screw (Position: left side of
machine close to pull start handle)
21