Front Wheel - Yamaha WR25RB Owner's Manual

Front wheel

To remove the front wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the front wheel axle pinch
bolts and axle nut.
1
1. Front wheel axle pinch bolt
2. Axle nut
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU24360
1
EAU45163
EWA10821
2
1. Front wheel axle pinch bolt
2. Wheel axle
2. Lift the front wheel off the ground
according to the procedure in the
previous section "Supporting the
motorcycle".
3. Remove the axle nut.
2
4. Pull the wheel axle out.
5. Remove the spacers and the
wheel. NOTICE: Do not apply the
brake after the wheel has been
removed together
brake disc, otherwise the brake
pads will be forced shut.
To install the front wheel
1. Install the spacers into both sides
of the wheel hub. NOTICE: When
7-41
installing the spacers, be sure
to install them on the correct
side.
[ECA17700]
2. Lift the wheel up between the fork
legs.
TIP
Make sure that there is enough space
between the brake pads before install-
ing the brake caliper onto the brake
disc.
3. Insert the wheel axle from the
right-hand side.
4. Install the axle nut.
5. Lower the front wheel so that it is
on the ground, and then put the
sidestand down.
6. Tighten the axle nut, and then the
front wheel axle pinch bolts to the
specified torques.
Tightening torques:
with the
Axle nut:
63 Nm (6.3 m·kgf, 46 ft·lbf)
Front wheel axle pinch bolt:
[ECA11071]
23 Nm (2.3 m·kgf, 17 ft·lbf)
EAU45174
7. Push down hard on the handlebar
several times to check for proper
fork operation.
2
3
4
5
6
7
8
9