Yamaha WR25RB Owner's Manual page 23

1 2
3
1. Stopwatch indicator " "
2. Tripmeter A indicator " "/Distance-com-
pensation tripmeter " "
3. Tripmeter B indicator " "
TIP

The multi-function display can be
set to the basic mode or the mea-
surement mode.

Tripmeter A will automatically re-
set to zero when changing from
the basic mode to the measure-
ment mode or vice versa.
Basic mode:

a speedometer

an odometer

two tripmeters (which show the
distance traveled since they were
INSTRUMENT AND CONTROL FUNCTIONS
last set to zero)

a fuel reserve tripmeter (which
shows the distance traveled since
the fuel level warning light came
on)

a clock

a self-diagnosis device
Measurement mode:

a speedometer

a distance-compensation tripme-
ter (which shows the accumulated
distance traveled since set to zero
and which can be calibrated to pro-
vide a more accurate tripmeter
reading)

a stopwatch (which shows the time
that has been accumulated since
the start of stopwatch measure-
ment)

a self-diagnosis device
TIP

Be sure to turn the key to "ON" be-
fore using the "SELECT 1", "SE-
LECT 2" and "RESET" buttons.

When the key is turned to "ON", all
of the display segments of the
multi-function display will appear
4-4
and then disappear, in order to test
the electrical circuit.

To switch the speedometer and
odometer/tripmeter displays be-
tween kilometers and miles, press
the "SELECT 2" button until the
display changes after the key is
turned to "ON".
Basic mode
Odometer and tripmeter modes
Push the "SELECT 2" button to switch
the display between the odometer
mode and the tripmeter modes A and B
in the following order:
odometer  tripmeter A  tripmeter B
 odometer
2
3
4
5
6
7
8
9