Table of Contents
Advertisement
It recommends using PLANET SFPs on the Switch. If you insert a SFP transceiver that is not
Note
supported, the Switch will not recogniz
:
Before
connect the other switches, workstation or Media Converter.
1
.
Make sure both side of the SFP transfer are with the same media type, for example: 1000Base-SX to 1000Base-SX,
1000Bas-LX to 1000Base-LX.
2.
Check the fiber-optic cable type match the SFP transfer model.
To connect to 1000Base-SX SFP transfer, use the multi-mode fiber cable- with one side must be male duplex
LC connector type.
To connect to 1000Base-LX SFP transfer, use the single
plex LC connector type.
Conne t
c the fiber cable
1.
Attach the duplex LC connector on the network cable into the SFP transceiver.
2.
Connect the other end
Converter..
3.
Check the LNK/ACT LED of the SFP slot on the front of the Switch. Ensure that the SF
correctly.
4.
Check the Link mode of the SF
Link mode to "1000 Force" is needed.
of the cable to a device – switches with SFP installed, fiber NIC on a workstation or a Media
P port if the link failed. Co works with some fiber-NICs or Media Converters, set the
e it.
-mode fiber cable-with one side must be male du-
P transceiver is operating
- 12 -
Advertisement
Table of Contents
