Figure 10-Warning Label - Inspect Blades Before Use; Figure 11 - Pointer Wheel Adjustment - EINHELL JS SERIES Operation And Maintenance Manual

Table of Contents

Remove bolt in the blade guard holding bracket. Hold the blade guard firmly and raise guard up into

5.8

the holding bracket. Reinsert bolt in the blade guard holding bracket and tighten nut.

Remove both blade change wrenches from the JS handle. Install dry cut diamond blade. See

5.9

section 8.1 for detailed instructions on removing and installing blades. Inspect diamond blades for

damage at least twice daily and before each use. Damaged diamond blades are hazardous and

should never be used on a JS. See Figure 10.

5.10

Replace the wrenches in the holding bracket on the handle. Tighten the wrench-clamping knob.

5.11

Check the belt tension each day before starting work. Check after the first hour of operation if the JS

or belt is new. See section 8.3 for detailed instructions on checking and adjusting the belt tension.

Move the front and rear pointer arms down towards the ground. Turn the height adjustment handle

5.12

clockwise until the blade touches the ground. Now turn the adjustment handle counter-clockwise

one complete 360° turn. This will raise the blade slightly off the ground.

Using the marked chalk line or any straight line on the ground, align the blade with the line. On the

pointer wheels, loosen the adjustment nuts and align the wheels with the same chalk line. Push the

5.13

JS along the line to verify the alignment is straight. See Figure 11 and Figure 12.

WARNING

To avoid injury:

Always inspect saw

blades before use.

Replace all cracked

or damaged blades.

B2001 HCS, LLC

Figure 10 - Warning label - inspect blades before use

POINTER WHEEL

No. H6110-M1WVPK

ADJUSTMENT NUTS

INTENDED CUT LINE

Table of Contents