Pre-Operation Checklist; Figure 3-Warning Label - Read And Understand Manual - EINHELL JS SERIES Operation And Maintenance Manual

Hide thumbs

Table Of Contents

Table of Contents

4.34

CHECK DAMAGED PARTS.

Verify all machine guards are in good condition and will function properly before using the machine.

Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and

any other conditions that may affect machine operation. A guard, power switch or other part that is

damaged should be properly repaired or replaced by an authorized service center unless indicated

elsewhere in this instruction manual. Do not operate machine if deadman lever or engine on/off

switch does not function properly.

4.35

SECURELY MOUNT ACCESSORIES AND BLADES TO THE MACHINE.

Extra care must be taken when using saws on an elevated location to prevent injury to someone on a

lower level in the event the tool or accessory should drop. Do not operate without fall protection for

operator and debris protection for public.

4.36

NEVER TOUCH THE MOVING PARTS.

Never touch moving parts such as blades, belts and others.

4.37

STOP OPERATION IMMEDIATELY IF ANY ABNORMALITY IS DETECTED.

Stop using machine immediately if any abnormalities are observed during operation. Examples of

abnormalities include unusual noise and vibration.

4.38

WHEN REPLACING A PART, USE THE SAME TYPE AND QUALITY.

When replacing a component part with a new one, use only the same type and quality of new part.

Never attempt to repair a machine if you are unfamiliar with proper procedures and techniques

required.

4.39

DO NOT MODIFY MACHINE.

Do not modify machine from its original design without written permission from the manufacturer.

Non-authorized modifications could lead to serious injury or death and void warranty.

4.40

NEVER DISABLE THE DEADMAN LEVER.

Do not modify, disable, or attempt to permanently engage the deadman lever. Do not operate a

machine if deadman lever is not functioning. This could lead to serious injury or death.

4.41

SAVE THESE INSTRUCTIONS.

Refer to this operations and maintenance manual as well as any additional instructions included

from other manufacturers and organizations such as Honda® and the Masonry and Concrete Saw

Manufacturers Institute®. Never permit anyone to operate the machine without proper instructions.

Figure 3 - Warning label - read and understand manual

5.1 Start by reading the entire Honda Engines Owner's Manual, Rx for Diamond Blade Safety, and Rx

for Concrete Saws by the Masonry and Concrete Saw Manufacturers Institute. Then, read the

entire JS operations and maintenance manual. Get familiar with the machine's parts. See Figure 1

through Figure 32.

5.0