Britax MAXI GUARDSICT8300 A 2013 series Instructions For Installation & Use page 21

INSTALLATION OF CAR'S UPPER
ANCHORAGE POINT
IF THE CAR IS FITTED WITH CHILD RESTRAINT
UPPER ANCHORAGE POINT
Locate the upper anchorage point behind the rear seating position.
(Consult the car owners handbook for the location of the upper
anchorage point). The upper anchorage point should be directly
behind and central to the restraint. Remove thread plug from the
parcel shelf/floor/roof, etc. and install attachment bolt and fitting as
shown in Fig 1.
CAUTION: DO NOT OVERTIGHTEN ATTACHMENT BOLT.
OVERTIGHTENING MAY FRACTURE OR BREAK BOLT.
MAXIMUM TORQUE IS 20 Nm(14.75 ft.lb.)
Note: Minimum of five full turns of attachment bolt is required before
tightening force is applied.
IF THE CAR IS NOT FITTED WITH CHILD
RESTRAINT UPPER ANCHORAGE POINTS
For Sedans only - Drill 9mm diameter hole in the parcel shelf
on the centre line of the seating position as shown in Fig 3. Before
drilling the hole, check the underside for accessibility. Install the
attachment bolt as shown in Fig 2. It is recommended that this
installation be carried out by a child restraint fitting station or
licenced motor mechanic.
For vehicles other than Sedans - In Australia, consult your
nearest child restraint fitting station or traffic authority for vehicle
inspection to find the best, correct position for the placement of
the upper anchorage point, and for the correct attachment bolt
length and use of spacers. In New Zealand, consult the agent
for the vehicle. Note to Queensland purchasers: The installation
of anchorage points must be approved by authorised officers
appointed by Queensland Transport. Authorised officers can be
sourced from all Queensland Transport Customer Service and
Queensland Ambulance Service Centres.
40
Instructions for Installation & Use - Series No. 8300/A/2013
UPPER ANCHORAGE FITTING
Fig.1.
Attachment Bolt
Lock washer
Anchor fitting
Spacer(s) if
required
Vehicle trim
Vehicle metal
structure
Front of Vehicle
UPPER ANCHORAGE
FITTINGS FOR SEDANS ONLY
Fig.2.
Attachment Bolt
Anchor fitting
Spacer(s) if
required
Vehicle trim
Vehicle metal
structure
Reinforcing
washer (cone
downwards).
Lock washer
Secure nut
INSTALLATION OF CAR'S UPPER
ONLY USE A 5/16 UNC GRADE 5 BOLT. IF THE BOLT IS NOT THE
CORRECT LENGTH THE CAR MANUFACTURER'S HAND BOOK
CAN PROVIDE ADVICE ON THE CORRECT LENGTH BOLT.
CHILD RESTRAINTS MUST NOT BE ATTACHED TO UNSOUND
METAL OR TO WOOD, OR SYNTHETIC STRUCTURES. WHEN
DRILLING 9 MM HOLE DO NOT DRILL THROUGH FUEL LINES,
FUEL TANKS, ELECTRICAL WIRING, OR RADIO SPEAKERS.
WEBBING STRAPS MUST BE PROTECTED FROM SHARP
CORNERS AND EDGES. THE ANCHOR FITTING MUST BE USED
ONLY AS DESCRIBED ABOVE. IT MUST NOT BE HOOKED ONTO
ANY OTHER OBJECT.
CAR INSTALLATION ACCESSORIES
(From retailers of Britax Safe-n-Sound products)
EXTRA ANCHOR KITS: Available for using the restraint in additional cars.
Re-order no: 0038
EXTENSION STRAPS: May be required for cars without a fixed parcel shelf.
Re-order no: 0035 (length 300mm) or
0036 (length 600mm)
Instructions for Installation & Use - Series No. 8300/A/2013
ANCHORAGE POINT
NOTE: Marking on
the top of a Grade 5
Bolt. Do not use any bolt
without these marks.
Front of Vehicle
200mm
min.
Centre line of
Fig.3.
seating position
41