Britax MAXI GUARDSICT8300 A 2013 series Instructions For Installation & Use page 11

HOW TO INSTALL
C. Position restraint centrally to the chosen vehicle seat position in forward facing mode.
Some vehicle seat fabrics (particularly velours) may be damaged by a child restraint used continuously.
We recommend the use of the Britax Safe-n-Sound™ Messy Mat or other protection under and behind
the seat to keep the vehicle seat in good condition.
Pull the centre panel flap down and gently lift headrest trim end.
Fully lengthen seatbelt and feed the seatbelt through the closest
seatbelt path slot and pass across the seating surface through the
opposite slot. Follow the yellow belt path label -
FACING BELT PATH
and engage the seatbelt tongue
into the buckle and remove all slack.
Engage into
Seatbelt
buckle
Near
seatbelt slot
20
Instructions for Installation & Use - Series No. 8300/A/2013
Headrest trim end
FORWARD-
Centre
panel flap
7
Yellow Belt Path label
FORWARD-FACING
BELT PATH
Seatbelt feeds
through slot in seat
between trim and
seat back.
D. Lengthen the top tether strap and connect
the attachment clip to the car's upper
anchorage point making sure to remove as
many twists as possible.
To lengthen the top tether strap, fully press
adjuster button (A) while pulling top tether
strap (B) to slacken as shown right.
Refer to your vehicle owner's manual for
the location of the upper anchorage point
in the car. If the vehicle is not fitted with a
child restraint upper anchorage point then
refer to page 38 to 41 for the installation of
the upper anchorage point provided with
this child restraint.
E. Push down on the restraint to compress it
into the vehicle seat. Whilst compressed in
Car's
seatbelt the seat, pull on the lap portion to remove
all slack from the belt. Pull the sash belt
and allow excess belt to feed back into the
retractor. Ensure all slack is removed from
the lap and sash belt.
F. The restraint should be held firmly against the
vehicle seatback.
CAUTION:
CHILDREN CAN BE INJURED OR RESTRAINTS AND TOP TETHER STRAP DAMAGED BY
UNSECURED CARGO IN A COLLISION. SECURE OR REMOVE HAZARDOUS CARGO BEFORE
USING THIS CHILD RESTRAINT.
HOW TO INSTALL
Attachment Clip
Fully press Adjuster Button (A) while pulling top tether
strap (B) to lengthen.
Push
down
Instructions for Installation & Use - Series No. 8300/A/2013
Car's Upper
Anchorage Point
A
B
Remove all
slack from
lap portion,
then sash.
21