Britax MAXI GUARDSICT8300 A 2013 series Instructions For Installation & Use page 14

HOW TO USE
C. Release the AHR Easy Adjust Headrest
Lever so that it locks into position. Ensure
that it has locked in position by gently
pushing down on it.
D. If the headrest is adjusted with the child in
the seat, always check that the cover has
not bunched up behind the child's back.
NOTE: For comfort ensure the bottom edges
of the headrest are not contacting the child's
shoulders but just above the shoulders.
PLACING CHILD IN THE
RESTRAINT
A. Place the child in the restraint and feed
each arm through shoulder straps. Pull the
harness buckle up between child's legs.
Engage the buckle tongues and tighten the
harness as described on the next page.
IMPORTANT :
Always adjust the height of the shoulder
straps as the child grows.
26
Instructions for Installation & Use - Series No. 8300/A/2013
Lift the lever
at the top of
the headrest
then pull
up or push
down
Pull shoulder strap
through the buckle
Then, pull harness
adjuster strap to tighten
B. Fit either harness buckle tongue into the harness buckle
followed by the other tongue. A click is heard when the
last tongue is fully engaged.
Should the second tongue not insert - press the
red button and reinsert the tongues. Check secure
engagement by pulling harness straps. If the harness
buckle does not engage correctly then it may require
cleaning or seek replacement - refer to page 29.
C. Ensure slack is removed from harness lap strap by pulling
shoulder straps then pull harness adjustment strap to
adjust harness to a comfortable but firm fit. Ensure that
all slack in harness straps is removed. Shoulder harness
straps must fit firmly to the child. A loose harness could
result in serious injury in an accident.
D. Pull the harness adjustment strap to remove slack so
the harness fits the child with minimal slack. Do not over
tighten.
Do not use restraint if straps do not tighten and contact your
local authorised service agent for repair.
WARNING : DO NOT LEAVE
CHILDREN UNATTENDED IN
THE CAR.
TO REMOVE CHILD FROM RESTRAINT
Press the red button on harness buckle then both harness tongues will be released. You may lengthen the
harness by pressing the adjuster button or lifting the adjuster lever and pulling the shoulder straps. Move
each shoulder strap to the child's side, then remove the child.
If the buckle tongue holders are provided then store the tongues in these.
Instructions for Installation & Use - Series No. 8300/A/2013
HOW TO USE
Tongue
Buckle
Click
B
Pull to remove slack from
harness lap straps
Shoulder
Straps
Harness
Lap Straps
Crotch
C
Straps
27