Assembly - Gardena EasyCut Li-18/23 R Operating Instructions Manual

The charging cable should be checked regularly
for signs of damage or ageing (brittleness) and
may only be used if it is in perfect condition.
The charger unit provided may only be used to
charge the rechargeable batteries supplied with
the Turbotrimmer.
Non-rechargeable batteries must not be charged
with this battery charger (danger of fire).
The Trimmer must not be operated during
charging.

3. Assembly

Assembling the trimmer:
o
h
j
g
t
2
e
w
3
ö
k
14
CAUTION!
The handle may only be assembled if the cable
between the handle and the shaft is in a perfect
condition. The handle may not be assembled if
the cable is damaged. Contact GARDENA customer
service in such a case.
CAUTION!
The trimmer may only be operated provided that the
protective cover
1. Carefully remove the handle
1
the packaging. In doing so, no stress may be exerted upon the
cable.
2. Ensure that the threaded collar
(padlock symbol open).
3. Slide the handle
In doing so, the cable may not become twisted or jammed.
4. By pulling on the handle
the shaft
be separated.
5. Close the threaded collar
6. Pull the lock
both of the snap-fits
and, with the grooves pointing forwards, snap them into the
holder
j
7. Only for art. 9825: Place both halves of the impeller
the lower groove
audibly engage.
8. From the front, push the plant guard
groove
0
0
the impeller
l
the kink pointing upwards).
Only charge battery between 0 – 45 °C.
After heavy duty service allow battery to cool
down first.
Only the original GARDENA battery may be used.
Storage
The trimmer must not be stored over 35 °C or
under direct exposure to sunlight.
Do not store the trimmer in places with static
electricity.
is assembled.
q
1
onto the shaft
1
, check whether it is firmly fixed to
1
. Once assembled, the handle
2
(padlock symbol closed).
t
belonging to the additional handle
o
belonging to the additional handle
g
.
of the trimmer head
l
of the trimmer head
3
can rotate freely (i.e. insert the bow with
k
together with the shaft
is in an open position
t
until it audibly engages.
2
and shaft
1
, push in
h
k
and close until they
3
into the upper
ö
. In doing so, ensure that
from
2
cannot
2
h
around