Nilfisk-Advance SC500 Operating Instructions

ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual
1a. Unplug the Battery charger cable. 2. Fill the tank with a clean water. The
Reconnect it to the machine.
1b. Disconnect the battery charger
cable from the electrical socket.
6. Insert the operator key, then start 7. Lower the squeegee with the pedal.
the machine by pressing the One-
Touch button. To engage the brush,
slightly press the drive paddle and
then release it.
At the end of the work
11. Press the EcoFlex™ button when- 12. Machine with Ecoflex, always end the daily
ever you temporarily need a greater
cleaning power.
16. Press the click-off button and wait 17. Take the squeegee off and remove
for the brush/pad holder to fall
on the floor. Remove to clean or
change brush.
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this
procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE THE CHARGER IS ALWAYS CONNECTED TO THE BATTERIES EVEN IF NOT USED FOR LONGER PERIOD OF TIME TO PREVENT DAMAGE TO THE BATTERY DUE TO LOW VOLTAGE
Nilfisk-Advance A/S Tel.: +45 43 23 40 50
Sognevej 25 Fax: +45 43 43 77 00
DK-2605 Brøndby mail.com@nilfisk-advance.com
Denmark www.nilfisk.com
3. Fill the EcoFlex™ tank with a deter-
clean water temperature must not gent suitable for cleaning machines
exceed 40 °C. (highly concentrated and low
Make sure the solution valve under foaming detergent).
the machine is open.
8. Push forward the drive paddle to start
cleaning. Adjust maximum speed by
the speed regulation buttons.
13. Empty the recovery tank with the
work with turning off the detergent 2 minutes
before finishing by pressing the detergent but-
ton. To rinse out detergent from the system and
brush before handling and cleaning.
18. Clean the machine using a damp
debris. Check and clean the squeegee
blades.
OPERATING GUIDELINES
SC500
4. Install the squeegee and fasten it
with the knob.
9. To change the solution flow level
push the solution button and
change flow level according to the
cleaning performance and applica-
tion.
14. Empty the debris tray and clean/
hose. Then empty the solution tank wash the recovery tank inside.
with the transparent hose.
19. Charge the batteries: Connect the
battery charger cable to the electri-
cloth and where needed use a neu-
tral cleaning product. cal socket.
5. Place the brush or the pad-holder
under the deck. Use the appropriate
brush to clean the floor.
10. If necessary press the extra pressure
function (hold for one second).
If necessary press the silent mode
button for extra low sound level.
15. Clean the filter:
A) Close the solu tion valve under the machine.
B) Remove the transparent cover and the gasket,
then remove and clean the filter inside.
C) Reassemble the filter.
20. Park the machine with the recovery
tank cover open.