Nilfisk-Advance SC500 How-To Manual

1
This is how the machine
should look when you
enter the room.
1
Install pad under deck.
Line up evenly
(do not
remove center section of
.
To remove primary
pad)
pad, slide hand between
pad and scrub-head face
Disc Pad or Brush Installation & Preparation for Use Continued
1
Install brush manually by
lifting brush into place
then slightly rotate to lock
in place.
Inspect blades for wear. If
2
worn, remove retaining
strap, flip or replace
blades, install squeegee.
Do not over tighten
knobs.
www.totalwarehouse.com
833-868-2500
SC500 How To
Prepare for Use
2
Disconnect battery
charger, store onboard
charger cord and lower
the recovery tank lid.
Pad and Brush Installation REV Model
Floor finish removal –
2
First - Install a new
primary floor pad
. Pre-wet spp
white only)
pad. Then install SPP pad
(
between the primary floor pad
.
and the floor)
2
Install brush automatically –
center brush or pad under
scrub head, set to minimum
speed, activate scrub
system then press motion
paddle to start scrub system.
3
Do a walk-around
inspection.
with clean
not exceed 104°F).
system – add correct
detergent.
3
3
(red or
.
1
4
Fill machine
water (water should
EcoFlex
Inspect and prepare to
Install proper pad or
brush under the deck.
Rev brush is optional. To
install align brush tabs
and scrub head then
tighten thumb screws.
Verify recovery tank is
empty, inspect ball float
and cage and inspect
debris catch cage.
Turn on machine and verify
battery power. Press paddle
forward or pull for backward
motion
(adjust speed if needed)
Change steering direction by
pushing handle to left or
right. Transport to cleaning
area.
www.totalwarehouse.com
833-868-2500
.