Table of Contents
Advertisement
Section 2
Rear Panel:
1. Gas Supply. Connect the Gas regulator hose to
this point via the brass barb fitting. The hose
barb connection must be tight to prevent gas
leakage. Install an extra clamp if needed to
prevent gas from escaping. Test for leaks with
soapy water. Do not leave gas valve open on
cylinder when not attended or in use.
2. Power Switch. Turns unit on or off.
3. Power Input Cable. The unit operates on 120V
input power. This is a standard NEMA 5-15P
plug used in North America.
4. Fan. The welder fan is designed to run contin-
uously while the unit is switched on. It may con-
tinue to run for up to 5 seconds after the welder
has been switched off while the capacitors dis-
charge. This is normal and not an issue. Keep
at least 18" away from obstructions to allow
proper cooling. Do not allow grinder dust or
sparks to enter the fan. Periodically inspect fan
for metal dust build up. Metal particles can
build up on the fan over time and can unbalance
the fan and damage it.
Setup Guide and component Identification
21
Hide quick links:
Advertisement
Table of Contents
