Finding The Camera's Ip Using The Bnc Test Cable; Configuring Remote Connection - eLine ELI-SIP-B21-312R Instruction Manual

2. Click Bonjour. The camera's IP address appears in the Bonjour Devices
list.
3. Double-click the camera to open it in Safari®.
Bookmarks
button
Bonjour
4. Under User Name and Password, enter the camera's User Name
(default: admin) and Password (default: admin) and click Login.
Enter Camera User Name (default: admin)
Enter Camera Password (default: admin)
Click Login
4.4 Finding the Camera IP using the BNC Test Cable
When the BNC test cable is connected to the camera, the IP address is shown
on the test monitor. The camera must be connected to power to use the BNC
test cable.
NOTE: The default IP address of 192.168.0.120 is shown if the camera
cannot obtain an IP address from the router. Check the Ethernet/power
connections and router configuration.
eLine Technology
11
Finding the Camera's IP Address
Double-click the camera's IP address

Configuring Remote Connection

5. CONFIGURING REMOTE CONNECTION
Follow the steps below to configure your camera for connections over the
Internet using a web browser, NVMS, or other VMS software.
Step 1 of 6: Locate the camera's local IP address:
• See "4. Finding the Camera's IP Address" on page 8.
Step 2 of 6: Port Forward your router:
You need to enable port forwarding for the following ports on your router to
the camera's local IP address:
• HTTP Port (default: 80)
• Control Port (default: 30001)
NOTE: If you are configuring multiple IP cameras for individual remote
access, you must change the ports for each camera. Two cameras cannot
use the same port number.
NOTE: Port forwarding the RTSP and RTMP ports is not necessary unless
your installation has special requirements.
There are two methods for port forwarding:
• You can manually port forward your router. See your router's user manual
for details. An example of a port forwarding screen is shown below.
HTTP 80 80
30001
Control 30001
100
100
eLineTechnology.com
12