Operating Instructions; Addr - Dmx Address Setup; Chnd - Dmx Channel Modes; Slnd - Master/Slave Setup. Soun - Sound Sensitivity Setup - Stagg HEAD BANGER 10 SLI MHW HB10 User Manual

Operating Instructions

Take note: All changes made to the unit become active and saved when the unit
exits it's menu. This is activated by not touching the control buttons for 5
seconds. The unit will then display the active running mode (NST/SL1/SL2 for
Sound Control, AUTO for Automatic Programs or the DMX address when DMX
input is detected).

ADDR - DMX Address Setup

• Press MENU, then Up or DOWN until "ADDR" is displayed, then press ENTER
• Change the DMX address by pressing UP or DOWN
• Press ENTER to save the DMX address
CHND - DMX Channel Modes
• Press MENU, then UP or DOWN until "Chnd" is displayed, then press ENTER
• "X Ch" will now be displayed. "X" represents the DMX mode you have
selected (see DMX channel charts for reference). Choose your desired DMX
mode with UP or DOWN and press ENTER to confirm.
SLND - Master/Slave Setup
• Press MENU, then UP or DOWN until "SLND" is displayed, then press
ENTER
• "Nast": The unit becomes the master in the Master/Slave chain and should be
the first light in it. All slave lights should be daisy-chained from the output of
the master
• "SL1/SL2": The unit becomes a slave unit that follows the master unit when
Automatic Programs or Sound Control is activated. SL1 does exactly the
same, SL2 puts a little offset on the program so it does not run symmetrical
and gives dynamic to the show.
• Press ENTER to confirm
SOUN - Sound Sensitivity Setup
• Press MENU, then UP or DOWN until "SOUN" is displayed, then press
ENTER
• You can adjust the sensitivity of the internal microphone using the UP or
DOWN buttons, press ENTER to confirm.