Quick Reference - Phonak TX-300V User Manual

tx-300v studio manual_2006_01_20.qxp

Quick Reference

TX-300V Front Panel: Controls & Displays
Adjust audio input levels
of Input 1 and Input 2
here. See page 9 for more
information
Test Tone: Acti-
Power
vates a tone to aid
ON / OFF
system setup
TX-300V Back Panel: Connections & Settings
Remote Antenna Connection:
See page 8 for details on
antennas that can be attached
here
Set RF Power level here (Ľ, ˝ and
Full). See page 7 for guidelines on
setting power levels
6
2/1/2006 12:02 PM
Indicates audio input
level of Input 1 and
Shows mixed
Input 2
audio level
Mix Level: Adjust so Contour: Equalization
the Mix Level meter adjustment. Turn
occasionally lights counter-clockwise for
the red LED voice and clockwise for
music
Mix Output: These
connectors contain a mix of
Input 2: Set switch to
Input 1 and Input 2. They are
match the level of your
unbalanced phono connectors;
Input 2 audio source.
and the output level is -10dBu
Input 2: Connect unbalanced
audio to these phono
The power supply
connectors, input level -10dBu
connects here
or +10dBu
Page 6
Indicates Pro-
cess Mode
is active
LCD: Shows
which channel
is selected
Channel Select Down:
Channel Select Up:
Press for 8 seconds to
Press for 3 seconds to
enter program mode.
lock on current
See page 9 for more
channel
information
Input 1: Used for balanced
connection of a microphone or
line level input. This
combination connector accepts
either XLR or phone
connectors
Select Line, Mic or Mic+Phantom
Power. Line is balanced 0 dBu
input level, Mic is -55dBu,
+12VDC supplied in PH PWR
position. If not using input 1, leave
in line position.
Monitor Port:
Plug in a headset
and adjust volume