D-Link Nvr Search Utility; Mac - D-Link DNR-322L User Manual

Section 3 - Configuration
Insert the CD, go to the CD directory, then enter the Mac Utility folder. Click the NVR Search Utility file to run this useful
setup tool. When first powered on, during the initial boot sequence the device will wait to be assigned an IP address via
DHCP. If it does not receive a DHCP-assigned IP address the Auto-IP process will assign a 169.254.xxx.xxx address to the
device. If you want to change the IP address before logging in or are unable to connect to the NVR IP address, you can use
the NVR Search Utility provided on the product CD to locate the device on your network and make any needed changes.
Network Video The D-Link NVR Search Utility displays any NVR devices it detects on
Recorder: the network.
Refresh: Click to refresh the device list.
Click Configuration to access the Web-based configuration of the
Configuration:
NVR.
LAN:
Configure the LAN Settings for the NVR.
Receive DHCP:
Select Enable to use DHCP for your LAN IP settings, or Disable to use
static IP.
Apply:
Click Apply to save and activate the changes to the LAN Settings.
Drive Mounting:
Volumes available for mounting are displayed here.
Click Connect to mount the selected volume. Click Disconnect to
unmount the selected volume.
About:
Click About to view the software version of the NVR Search Utility.
Exit:
Click Exit to close the utility.
D-Link DNR-322L User Manual

D-Link NVR Search Utility

Mac

41