Advertisement
18
en | Installing a Recessed Mount
11. Align trim ring so the four alignment posts (item 1, below)
12. Snap trim ring into place. Ensure snaps are secure by
13. Use the supplied T-10 Torx wrench to secure the trim
F.01U.201.538 | 1.0 | 2010.12
align with the recesses in the camera housing (item 2) and
so the two safety screws align with the off center holes
(item 3) on the locking clamps.
Note: The two (2) sets of raised stand-off tabs (item 4) on
each side of the trim ring align with the locking clamps.
Figure 3.12 Align Trim Ring
1
Alignment Tabs (four)
2
Align tabs to the recessed areas on the housing
3
Align safety locking screws to these connections
4
Stand-off Tabs (two)
attempting to lightly turn unit. Note: Unit should not turn.
ring's two (2) safety locking screws to the mounting
bracket.
Mounting Guide
AutoDome Junior
Bosch Security Systems, Inc.
Advertisement
