Advertisement
14
en | Installing a Recessed Mount
14. Tighten both clamps using the clamp drive screws
NOTICE!
Over-torquing the ceiling clamps can damage the clamp or
ceiling. Only tighten the clamp until it contacts the ceiling and
you start to feel some resistance. If using a power screwdriver,
set the torque level to the lowest setting.
F.01U.201.538 | 1.0 | 2010.12
Figure 3.7 Attach Recess Mount to Ceiling
(installed on the assembly) and a #2 Phillips screwdriver.
Figure 3.8 Tighten Mounting Clamps
Mounting Guide
AutoDome Junior
Bosch Security Systems, Inc.
Advertisement
