Advertisement
AutoDome Junior
5.
6.
7.
8.
9.
Bosch Security Systems, Inc.
Attach the retaining ring with gasket (item 2, below) to the
VJR-A3-JW. These parts are supplied with the AutoDome
Junior Camera. Ensure that the side of the retaining ring
with the counter-sunk screw holes is facing you.
Figure 3.3 O-ring and retaining ring placement for outdoor installa-
tion
1
M3 – .5 x 6 Phillips flat head machine screws
(supplied with AutoDome Junior Camera)
2
Retaining ring with gasket
(supplied with AutoDome Junior Camera)
Determine the side of the VJR-A3-JW in which the external
wires are to be routed and remove the plug from the
knockout.
Apply a 1/2-in. (15-mm) NPS fitting to the chosen
knockout. Ensure a water-tight fitting to maintain the IP
Environmental Protection Rating for the unit.
Align the holes of the VJR-A3-JW with the mounting
bracket. Ensure that the VJR-A3-JW knockouts are not
covered by the bracket arms.
Thread the four (4) 3.97 mm I.D. by Ø1.78 mm O-rings
(item 1, Figure 3.4) onto the four (4) M4 x 16 Phillips Pan
Head Machine Screws.
Mounting Guide
Installing a Recessed Mount | en
F.01U.201.538 | 1.0 | 2010.12
11
Advertisement
