Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for MasterCraft 058-9321-6
Summary of Contents for MasterCraft 058-9321-6
- Page 1 INSTRUCTION MANUAL AIR-POWERED IMPACT WRENCH 058-9321-6...
- Page 2 QUICK START GUIDE TECHNICAL SPECIFICATIONS SAFETY GUIDELINES 4–9 KEY PARTS DIAGRAM IMPORTANT INFORMATION 11–13 OPERATING INSTRUCTIONS 14–15 MAINTENANCE 16–17 TROUBLESHOOTING 18–19 EXPLODED VIEW PARTS LIST WARRANTY 22–23 AIR-POWERED IMPACT WRENCH 058-9321-6...
- Page 4 PERSONAL SAFETY These precautions are intended for the personal safety of the user and others working with the user. Please take time to read and understand them. AIR-POWERED IMPACT WRENCH 058-9321-6...
- Page 5 Risk of personal injury: Do not direct compressed air from the air hose towards the user or other personnel. • Risk of inhallation: Never inhale the air produced by a compressor. Failure to comply will result in serious injury or loss of life. AIR-POWERED IMPACT WRENCH 058-9321-6...
- Page 6 Drain water from tank after each use. Do not weld or repair tank. Relieve all pressure in the hose before removing or attaching MC-OM-22 accessories. AIR-POWERED IMPACT WRENCH 058-9321-6...
- Page 7 Do not operate the compressor if it is not in a stable position. • Do not operate the compressor on a rooftop or in an elevated position that could allow the unit to fall or be tipped over. AIR-POWERED IMPACT WRENCH 058-9321-6...
- Page 8 Handling and storage of oil: Use with adequate ventilation. Avoid contact of oil with eyes, skin, and clothing. Avoid breathing spray or mist. Store in a tightly closed container in a cool, dry, well-ventilated area free from incompatible substances. AIR-POWERED IMPACT WRENCH 058-9321-6...
- Page 11 Wrench. The compressor should be able to supply a minimal air delivery of 5 SCFM @ 90 PSI to ensure the compressor can run continuously with the Mastercraft Air-powered Impact Wrench. Using a tool or combinations of tools that together or separately require more than compressor capacity will reduce performance and could void the guarantee/warranty of compressor or tool.
- Page 12 For proper adjustment of the in-line lubricator, place a sheet of paper next to the exhaust ports and hold the throttle open for approximately 30 seconds. The lubricator is properly set when a light stain of oil collects on the paper. Excessive amount of oil should be avoided. AIR-POWERED IMPACT WRENCH 058-9321-6...
- Page 17 When the tool is stored for longer period of time, apply an ample amount of lubricating oil before storing. • Run the tool for approximately 30 seconds after lubricating, in order to ensure that the lubrication is uniformly distributed throughout the tool. Store the tool in a clean and dry environment. AIR-POWERED IMPACT WRENCH 058-9321-6...
- Page 18 4. Disconnect the air supply. Operate the motor by manually rotating the drive shank (wherever applicable) Tool does not shut O-rings in the throttle valve are Replace O-rings. off. dislodged from the seat inlet valve. Note: For further repair information, please call 1-800-689-9928. AIR-POWERED IMPACT WRENCH 058-9321-6...
- Page 19 AIR-POWERED IMPACT WRENCH 058-9321-6...
- Page 21 Spring Cylinder O-ring 16 X 2.5 Bearing Spring Retainer ring Air deflector Seal washer Washer Rear washer Air inlet plug If any parts are missing or damaged and if you have any questions, please call 1-800-689-9928. AIR-POWERED IMPACT WRENCH 058-9321-6...
- Page 22 This warranty will not apply where damage is caused by repairs made or attempted by others (i.e., persons not authorized by the manufacturer). This warranty will not apply to any product that was sold to the original purchaser as a reconditioned or refurbished product (unless otherwise specified in writing). AIR-POWERED IMPACT WRENCH 058-9321-6...
- Page 23 This warranty gives you specific legal rights, and you may have other rights, which may vary from province to province. The provisions contained in this warranty are not intended to limit, modify, take away from, disclaim, or exclude any statutory warranties set forth in any applicable provincial or federal legislation. AIR-POWERED IMPACT WRENCH 058-9321-6...
Need help?
Do you have a question about the 058-9321-6 and is the answer not in the manual?
Questions and answers