Fujitsu Docomo F-07F Instruction Manual page 39

To change either code, perform the following
operation. When changing PIN1 code, set PIN1
entry ON/OFF to "ON" in advance.
meh Settingef
a
i UIM settingea Change PIN1 code
b Change PIN2 codeeAuthenticate
or
b
Enter the current PIN codeeEnter a
new PIN code in New PIN code field and
New PIN code - check fieldeC
[Save]
Point
To display the PIN1 code entry screen when turning
power on, mehficaeEnter PIN1 code,
and then set PIN1 entry ON/OFF to "ON".
Even if PIN2 code is locked by entering incorrect PIN2
code 3 times consecutively, making/receiving calls or
sending/receiving mail is available; if PIN code is
locked by entering incorrect PIN code 3 times
consecutively, these operations are unavailable.
The PUK code
PUK code is used if the PIN1/PIN2 code is locked.
PUK cannot be changed by users. If the docomo
mini UIM card is locked by entering the PUK code
incorrectly 10 times consecutively, contact
docomo Shop.
Point
The PUK code is written on a subscription form (copy
for user) handed at subscription in a docomo Shop.
For users subscribed in other than docomo Shop,
bring a document (a drivers license etc.) to identify
your subscription and the docomo mini UIM card to
a docomo Shop, or contact "General Inquiries" on the
last page of this manual.
Lock/Securitye
To set a security code, avoid imaginable
numbers such as "birth date", "a part of phone
number", "street address or room number",
"1111" or "1234". Maintain a separate record not
to forget the numbers.
Be careful never to reveal your security code to
others. If a security code is known to and
misused by others, DOCOMO assumes no
responsibility for damages resulted from it.
If you forget your security codes, you need to
bring a document (a drivers license etc.) to
identify your subscription, the FOMA terminal
and the docomo mini UIM card to a docomo
Shop. For details, contact "General Inquiries"
on the last page of this manual.
37