Operating Your Design Citrus Juicer Advanced - Gastroback Design Citrus Juicer Advanced Instructions For Use Manual

4. Place the juicing cone onto the drive shaft and press down lightly to lock
the cone into position (Fig. E & F).
important: If the drive shaft or the inside of the juicing cone are encrusted
with food residue, it is possible tah the juicing cone may not be attached
correctly. Do not use violence. Instead, first clean these partss (see ›Care
and Cleaning‹) and then assemble the appliance again.
warning:
never clean the drive shaft with hard or sharp objects and
do not apply any force handling these parts, otherwise you could damage
the seal of the drive shaft. The seal surrounds the drive shaft at the top of
the motorblock.
5. Insert the fruit dome onto the underside of the juicing press arm by alig-
ning the tab on top of the fruit dome with the hole in the juicing press arm
(Fig. G). Hold onto the juicing press arm and press the fruit dome up and
backwards until the dome locks into position.
note: The fruit dome is keyed, and can only be inserted in one way (this
will ensure that it does not rotate through operation).
6. Ensure the anti-drip juice spout is pushed down into the pouring position
(Fig. H).

operating your design citrus Juicer advanced

important: During the operation of the appliance pulp accumulates on
the stainless steel filter. Do not let the stainless steel filter get too full, since
the pressed juice might otherwise run over the edges of the juice collector
onto the motor block. Empty the stainless steel filter during longer operation
regularly. Also make sure that the juice spout in the juice collector is not
clogged. Do not let food food residue dry on the appliance or its parts.
warning:
During operation never put or hold any foreign objects
(eg spoons) into the stainless steel filter. Never place towels or cardboard
under the appliance. never place the aplliance on damp or wet surfaces.
never let any liquids run under or on the appliance. If during operation
any liquids should run under or through the motorblock, turn off the appli-
ance immediately, unplug from the power outlet and clean the jucer (see
›Care and Cleaning‹). never place your hands on the back of the apli-
ance between the motorblock and the juicing press arm. Make absolutely
sure that the appliance is properly and completely assembled and only
one stainless steel filter is inserted.
important: Your appliance will not operate if it is not assembled comple-
tely and correctly.
1. Ensure the citrus press is correctly assembled and a glass or jug is
placed under the juice spout before juicing (Fig. J).
23
E
F
G
H
I
J