Group Setup - Balter BTZ-2700 Instruction Manual

Group Setup

GROUP SETUP
------------------------
GROUP NO.
CLEAR GROUP
RUN GROUP
<EDIT GROUP>
BACK
EXIT
Group Edit
EDIT GROUP 1
------------------------
NO ACTION ### DWELL OPT
------------------------
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
------------------------
SAVE
CANCEL
EDIT GROUP 1
------------------------
NO ACTION ### DWELL OPT
------------------------
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
------------------------
SAVE [NEAR:EDIT ACT]
CANCEL [FAR :EDIT END]
Speed Dome Camera Instruction Manual
Group Number
1
UNDEFINED
CANCEL
Clear Group
Run Group
Edit Group
① Press Near key when the cursor is at "NO" to start
editing the selected Group.
[NEAR:EDIT]
② Note that MAX. 20 actions are allowed in a Group. Move
the cursor up/down to select an Action. Press Near key
to edit.
[1~8]
Selects a Group number to edit.
If the selected Group number is not
defined, "UNDEFINED"
displayed under the selected Group
number.
[CANCEL/OK]
Deletes the data of the selected Group.
Runs the Group for the test purposes to
check if it works properly.
Edit the selected Group.
4
OSD MENU
will be
43/53