Balter BTZ-2700 Instruction Manual page 13

Communication Protocol Setup
ON
ON
1 2 3 4
Speed Dome Camera Instruction Manual
Select an appropriate Protocol with the DIP switch combination.
Switch Mode
P0 P1
(Pin 1) (Pin 2)
OFF OFF
ON OFF
OFF ON
ON ON
Others
Match the camera protocol with the camera protocol in the setting of
your DVR or controller to control the camera.
Adjust the DIP switch after turning off the camera. If you changed the
camera protocol by changing the DIP S/W, the change will be effective
after you reboot the camera.
The factory default protocol is "Pelco-D, 2400 bps".
P2
(Pin 3)
OFF PELCO-D, 2400 bps
OFF PELCO-D, 9600 bps
OFF PELCO-P, 4800 bps
OFF PELCO-P, 9600 bps
INSTALLATION
Protocol
Reserved
2
13/53