Swing Setup - Balter BTZ-2700 Instruction Manual

Swing Setup

SWING SETUP
------------------------
SWING NO.
1ST POS.
2ND POS.
SWING SPEED
CLEAR SWING
RUN SWING
BACK
EXIT
Speed Dome Camera Instruction Manual
Swing
Number
1
NOT USED
NOT USED
1st Position
30/SEC
CANCEL
2nd Position
Swing
Speed
Clear Swing
Run Swing
[1~8]
Selects a Swing number to edit. If the
selected Swing is not defined, "NOT USED"
is displayed in the 1st Position and the 2nd
Position.
[PRESET 1~128]
Sets the 2 positions for a Swing function. If
the selected preset
"UNDEFINED" is displayed as shown
below.
SWING SETUP
------------------------
SWING NO.
1ST POS.
2ND POS.
When a swing function runs, the camera
moves from the preset assigned as the 1st
point to the preset assigned as the 2nd
point in CW(Clockwise) direction. Then
the camera moves
assigned as the 2nd point to the preset
assigned as the 1st point in CCW
(Counterclockwise) direction. In case that
the preset assigned as the 1st point and the
preset assigned as the 2nd point are same
or only 1 Preset position is assigned, the
camera turns on its axis by 360° in CW
direction and then it turns on its axis by
360° in CCW direction.
[1°/sec. ~180°/sec.]
Defines Swing speed between the 2 Preset
positions from 1°/sec to 180°/sec
[CANCEL/OK]
Deletes the data of the selected Swing.
Runs Swing for the test purposes to check
if it works properly.
4
OSD MENU
is not defined,
1
PRESET5
NOT USED
UNDEFINED
from the preset
41/53