Table of Contents
Advertisement
Alarm Input Setup
ALARM INPUT SETUP
------------------------
ALARM NO.
TYPE
ACTION
HOLD TIME
POST ACTION
BACK
EXIT
Speed Dome Camera Instruction Manual
Defines Alarm Function. When an alarm is receive, an
input signal to the camera triggers the user-defined action
programmed for the alarm.
1
Alarm No
N.OPEN
NOT USED
ENDLESS
Type
HOME
Action
Hold Time
Post Action [HOME/PRESET/PATTERN/SWING/GROUP
[1~3]
Selects a sensor number to set up.
[Normal OPEN/Normal CLOSE]
Selects sensor operation type.
[NOT
USED/PRESET/PATTERN/SWING/GROUP]
Selects an action to run when a sensor
signal is input.
[ENDLESS / 1~59 SEC. / 1~180 MIN.]
Sets the time period for the action which is
run by external sensor activation. After the
time period passes, the action pre-defined
in "Post Action" runs sequentially in
succession to the action by external sensor
activation.
If
this
"ENDLESS", "Post Action" does not
activate.
/PREV ACTION]
Selects the action that a camera will run
after the time period in"HOLD TIME"
passes.
If Post Action is set to "PREV.
ACTION", the camera runs the previous
action which it ran most recently.
4
OSD MENU
option
is
set
to
38/53
Advertisement
Table of Contents
