SoundCraft Ghost User Manual page 170

32) When I press a Channel SOLO
switch, and another PFL/AFL switch, I
don’t hear the Channel I have Soloed.
J) AUX Sends:
33) The AUX Sends are sending a dif-
ferent signal than I expect.
K) Oscillator & Talkback:
34) When I press the Oscillator’s TO
TAPE switch, I can’t hear the tone.
35) When I press any of the Talkback
Routing switches, I can’t hear my
voice.
36) When I press the TO TAPE switch
in both the Oscillator and Talkback
sections, I can only hear the Oscillator.
L) MAIN MIX:
37) When I press a Group TO MIX-
L+R switch, the Group signal is not
sent to the MAIN MIX.
10.6
32) SOLO-IN-PLACE (SIP) is activated.
33) One or more of the REV, MIX B
SRCE, or AUX 3-4 MIX B switches is
set incorrectly.
34) The OSC LEVEL knob is turned
down.
35) The TALKBACK Level knob is
turned down.
36) This is a normal condition.
37) The appropriate Group TO MIX-L
or R switch is not depressed.
32) When SIP is on and you activate a
Channel SOLO switch, the Channel sig-
nal is not sent to the PFL/AFL buses.
Instead, all UN-SOLOED Channels are
muted and you hear the SOLOED
Channels as the Control Room source.
Engaging any regular PFL/AFL switch
overrides the Control Room source and
you hear the PFL/AFL buses instead.
33) AUX 1-2 and STE AUX 7 will send
the signal routed to the Channel path
with the REV switch.
With the REV switch UP, AUX 3-4/5-6
will send the signal from the Channel
input, when the AUX 3-4 MIX B
switch is in the UP position. It will send
the signal from the MIX B input when
the AUX 3-4 MIX B switch is in the
DOWN position and the MIX B SRCE
switch is set to TAPE (UP). All this is
reversed when the REV switch is
depressed.
STE AUX 8 will send the signal assigned
to the MIX B path.
34) Turn the OSC LEVEL knob clock-
wise to increase the output level of the
Oscillator.
35) Turn the TALKBACK Level knob
clockwise to increase the output level
of the TB MIC, and make sure nothing
is blocking the TB MIC.
36) When the TO TAPE switch is
pressed in both the OSCILLATOR and
TALKBACK sections, the Oscillator
has precedence and you will only hear
its signal. To hear the TB MIC, make
sure the Oscillator’s TO TAPE switch is
off (UP).
37) The Group TO MIX-L+R switch
has no effect on the MAIN MIX routing
when pressed by itself. (See Note.) To
route odd-numbered Groups to the
MAIN MIX-L bus, press its TO MIX-L
switch, and to route even-numbered
Groups to the MAIN MIX-R bus, press
its TO MIX-R switch. To route any
Group to the MAIN MIX L+R buses,
press its TO MIX-L or R switch and its
associated TO MIX-L+R switch.Note:
The TO MIX-L+R switch also deter-
mines if the Group signal will be routed
to the PFL/AFL buses in Mono or
Stereo, when its associated AFL switch
is pressed.
GHOST Troubleshooting