Full Wheel Trim; Wheel Bolts; Anti-Theft Wheel Bolts - Skoda Citigo Operating Instructions Manual

Full wheel trim

Before removing the wheel bolts, remove the wheel cover.
Pulling off
›
Hook the clamp found in the vehicle tool kit
edge of the wheel trim.
›
Push the wheel wrench through the clamp, support on the tyre and pull off
the wheel trim.
Installing
›
Press the wheel trim onto the wheel rim at the designated valve opening
» .
›
Then press the trim into the wheel rim until its entire circumference locks
correctly in place.
CAUTION
Notes from the factory or from the ŠKODA Original accessory delivered trim.
When using an anti-theft wheel bolt, make sure that this has been fitted ac-
■
cording to the position marked on the back of the wheel cover position.
On the back of the wheel cover, the position for the anti-theft wheel bolt is
■
marked by means of a symbol. If the wheel cover is set outside the position
marked for the anti-theft wheel bolt, there is a risk of damaging the wheel
cover.
CAUTION
Use the pressure of your hand only, do not strike the full wheel trim. The
■
cover could be damaged.
If wheel trims are fitted, an adequate flow of air must be assured in order to
■
cool the brake system.
Note
We recommend that you use wheel trims from ŠKODA Original Accessories.
122
Do-it-yourself
» page 120 into the reinforced

Wheel bolts

Before removing the wheel bolts, remove the covering caps.
Pulling off
›
Push the extraction pliers » page 120
inner catches of the pliers are positioned at the collar of the cap.
›
Remove the cap in the direction of the arrow
Installing
›
Push the cap onto the wheel bolt up to the stop.

Anti-theft wheel bolts

The anti-theft wheel bolts protect the wheels from theft. These can only be
loosened or tightened with the use of adapter
›
Remove the full wheel trim or the caps of the wheel bolts.
›
Insert adapter » Fig. 111 with the toothed side all the way into the inner
B
teeth in the head of the anti-theft wheel bolts
›
Push the wheel wrench onto the adapter
›
Loosen or tighten the wheel bolt
›
Remove the adapter.
Fig. 110
Remove the cap
sufficiently far onto the cap until the
» Fig. 110.
Fig. 111
Principle sketch: Anti-theft
wheel bolt with adapter
» Fig. 111.
B
.
A
up to the stop.
B
» page 123.
