Skoda Citigo Operating Instructions Manual page 88

WARNING
The system only serves to support and does not relieve the driver of the
■
responsibility for the vehicle operation.
Moving persons or objects may not be recognized by the system sensors.
■
Under certain circumstances, surfaces of certain objects and types of
■
clothing cannot reflect the system signals. For this reason, such people or
objects may not be recognised by the system sensors.
External noise sources may affect the signals of the system sensors. Un-
■
der adverse conditions, this may cause objects or people not to be recog-
nised by the system.
Before reversing, you should make sure that there are no small obstacles,
■
such as rocks, thin posts, trailer drawbars etc. behind your vehicle. Such ob-
stacles may not be recognised by the system sensors.
CAUTION
Keep the system sensors clean, snow-and ice-free and do not cover with any
■
objects of any kind, otherwise the system functioning may be impaired.
Under adverse weather conditions (heavy rain, water vapour, very low or
■
high temperatures etc.), the system function may be limited - "incorrect recog-
nition of obstacle".
Additionally installed accessories such as e.g. bicycle carriers can impair the
■
system function.
Function
Fig. 87 Fitting the sensors / Range of sensors

Read and observe and
Range of sensors and acoustic signals
The clearance warning begins at a distance of about 150 cm from the obstacle
(area » Fig. 87). The interval between the acoustic signals becomes shorter
A
as the clearance is reduced.
A continuous tone sounds from a distance of approx. 30 cm (area
area. You should not reverse any further after this signal sounds!
Activation/deactivation
The system is activated by engaging reverse gear. This is confirmed by a brief
audible signal.
The system is deactivated by disengaging reverse gear.
Fault display
If a warning signal sounds for about 3 seconds after activating the system and
there is no obstacle close to your car, this indicates a system fault. Seek help
from a specialist garage.
Visual parking system

Read and observe and
The visual parking system is shown in the screen of the multifunctional device
Move & Fun.
Switching on the screen display of the visual parking system
When the ignition and the multifunction device Move & Fun are both on, the
visual parking system is switched on by shifting into reverse gear.
on page 85 first.
Fig. 88
Screen display of the visual park-
ing system
on page 85 first.
Assist systems
) – danger
B

85