Print Quality; Connectivity (Network Support) - Lexmark X543 Service Manual

Print quality

During the life of the printer, components are subject to wear based on usage. Printers continuously operating at
or near the maximum duty cycle may require service for replacement of these components to ensure high-
quality printing and good performance throughout the life of the printer. Replacement is recommended every
60,000 pages for the fuser and 60,000 pages for the ITU. The fuser and ITU replacement should be determined
by checking the last sheet of the Menu Settings Page. Either OK or Replace appears.
To print a Menu Settings page:
Press Menu (
1.
Select Reports from the Admin Menu, and press Select (
2.
Select Menu Settings, and press Select (
3.
Replacement is recommended every 30,000 pages for the imaging unit.
4800C Q (default) full printer speed
•
1200 dpi (reduced printer speed) is supported in PS and PCL only
•

Connectivity (network support)

✔
—Supported
✘
—Not supported
Network protocol
Standard Ethernet 10/100 Base T
Standard USB-B (Full speed) device
port
USB-A host ports
(In front, low/full speed) This port only
supports the following flash drives and
file types:
Supported flash drives: Lexar Jump
Drive 2.0 Pro (256/512 MB/1G
size) or SanDisk Cruzer Mini (256/
512 MB/1 G size)
Supported file
types: .pdf, .gif, .jpeg, .jpg,.bmp, .p
ng, .tiff, .tif, .pcx, .dcx
802.11n Wireless Network card
Manufacturing installs the wireless
card during the fabrication process. A
wireless card CANNOT be installed
post-manufacturing.
USB direct drive
) on the operator panel.
Lexmark
X543
✔
✔
✘
✘
Scan and
print (Select
formats)
).
).
Lexmark
X544n,
X544dn, Lexmark
X544dtn X544dw
✔
✔
✔
✘
Scan and print Scan and print
(Select
formats)
7525-xxx
Lexmark
X546dtn
✔ ✔
✔ ✔
✔ ✔
✔ ✘
Scan and print
(Select (Select
formats) formats)
General information
Previous
Next
Go Back
1-3