Note:
a) Acoustic information: the sound pressure level at the operator's ear should not
exceed 70 dB(A).
b) Vibration: the weighted RMS acceleration value at the hands when using this
machine should not exceed 2.5 m/sec
PREPARING FOR SPRAYING
The sprayer is delivered in a collapsed form.
assemble ready for spraying:
1) Extend the sprayer and securely connect the feed tube to the flow valve.
Instructions on assembling Micron Micropak backpacks are contained in the tank.
The shoulder strap (if supplied) should be connected to the battery case end cap.
Remove the atomiser protective cover and check by hand that the atomiser disc
spins freely.
2) Remove the switch end piece as
shown on the label.
N.B. Before spraying for the first time with the HERBI 4, the spray pattern produced
should be checked using only water (see 'BEFORE SPRAYING').
2
.
To
3) Insert four batteries (D-cell/R20)
negative, i.e. flat, end first.
5