Preparing For Spraying - Micron Electrafan 240 Instruction Manual

PREPARING FOR SPRAYING

Check that the intended mains supply corresponds to the lable on the machine before
fitting a plug to the mains cable (see 'ELECTRICAL SAFETY').
Before connecting to the mains supply check by hand that the atomiser assembly and
fan rotate freely by turning the atomiser assembly in an anti-clockwise direction. (Do
not touch the edge of the atomiser disc). If they are not free to rotate do not attempt
to start the sprayer but contact your supplier or Service Department at Micron.
Plug the sprayer into the mains supply and switch on to check smooth running of the
atomiser disc and fan.
The sprayer must only be used at the rated voltage. The machine must be switched
off in the event of power interruption or failure.
N.B. Before spraying for the first time with the ELECTRAFAN 110/240, sprayer
operation must be checked using only water (see 'BEFORE SPRAYING').
CAUTION. The Electrafan 110/240 are not designed for continuous running. A ther-
mal cut out is fitted to the motor to prevent the motor from over heating. If the motor
does over heat the sprayer will stop running, let the motor cool down and the thermal
cut out will reset enabling the operator to carry on spraying.
5