Preparing For Spraying - Micron Handy Instruction Manual

PREPARING FOR SPRAYING - NEW SCREW SWITCH
Air bleed tube
Locking screw
PARTS LIST AND DIAGRAM - NEW SCREW SWITCH
7465
1. Remove the green protective cover from the
atomiser disc.
2. Remove the switch end piece as shown on the label.
3. Insert four batteries (D-cell/R20) negative i.e. flat
end first, and replace the switch end piece
TURN ON
4. Make sure that the locking screw on the battery case
clamp is tight and that the air bleed tube is correctly
positioned in the groove as shown.
7464
7495
TURN OFF
DESCRIPTION
SCREW SWITCH PLUG
SCREW SWITCH SLEEVE
CONNECTOR SCREW SWITCH
5
PART
NO.
7464
7465
7495