Preinstallation Considerations; Select Location - AGA marvel M24TF Operation Manual

(50.8cm)
minimum
84 ⁄ " to 84 ⁄ "
1 7
4 8
(214cm) to (215.6cm)
"Cut out
Figure 4
Model
M24TF
M30TF
M36TF
NOTE
For models M24TF-WP, M30TF-WP, and M36TF-WP as-
semble the overlay door panels to the doors before install-
ing the cabinet into the rough in opening. Access to the
hinged side of the cabinet is required for door removal and
door installation. See page 17 for overlay door panel instal-
lation.
PRE INSTALLATION CONSIDERATIONS
22" (55.9cm)
20"
78 ⁄ " (199.4cm)
1
2
Minimum, typical
width"
24" (61cm)
Cut-Out Width
23 ⁄ " (59.7cm)
1
2
29 ⁄ " (74.9cm)
1
2
35 ⁄ " (90.2cm)
1
2
Table A
20"
(50.8cm)
minimum
78" (198.1cm)
approximately
24" (61cm)
NOTE
Floor under product MUST be at or above the same level
of the surrounding finished floor, for ease of installation and
removal of unit

Select Location

Locate the refrigerator/freezer in the coolest part of the
room, out of direct sunlight and away from heating ducts or
registers.
Do not place the refrigerator/freezer next to heat-producing
appliances such as a range, oven or dishwasher. If this
is not possible, a section of cabinetry or an added layer
of insulation between the two (2) appliances will help the
refrigerator/freezer operate more efficiently.
Do NOT install the refrigerator/freezer where the tempera-
ture will drop below 60 degrees F (15 degrees C) or rise
above 110 degrees F (43 degrees C). The compressor will
NOT be able to maintain proper temperatures.
7
Recommended
location of
water line
Figure 5